The reason for the sinking of the cylinder of the three tube dryer equipment is that the sinking of the cylinder causes the equipment to deviate from its original position. How to restore the horizontal position of the cylinder of the three tube dryer?

The three cylinder dryer restores the horizontal position of the cylinder body, with the purpose of making the vertical projection of the cylinder body busbar coincide with the reference line on the base again. The specific method is as follows:

a) When the measured diameters of two supporting wheels in the same gear are the same and the wear of the supporting wheel bearings is the same, the distance between the axis centerlines of the two supporting wheels and the reference center (original mark) can be adjusted to be equidistant.

b) When the measured diameters of two wheels in the same gear are different, the distance between the center line of the wheel with the smaller diameter can be adjusted smaller.

c) After adjusting both sets of supporting wheels, the centerline of the cylinder is generally reset in the horizontal direction.

Here is an introduction to the operation knowledge of drum dryer:

To improve the quality of the drum dryer, if the quality cannot be improved, then everything else will be in vain. Only a more sturdy drum dryer quality is the prerequisite for us to use the drum dryer well. Specifically, we hope that we can do a good job in this aspect, so that we can have certain development in all aspects. These are also things we need to do. In addition, we need to check our drum dryer before use to see if there are any problems. This is a good way to ensure the use of our drum dryer.

The above is the relevant content introduced by the manufacturer of the three tube dryer, hoping to be helpful to everyone.